BURKERT 63119 is a specific configuration of the Type 0330 direct-acting, media-separated pivoted armature valve. It is designed as a 2/2-way normally open (Circuit Function B) solenoid valve. The solenoid actuator and the medium chamber are separated from each other by a separating membrane system, making it especially suitable for critical or aggressive media such as acids and alkalis. This specific model features a polypropylene (PP) body, an EPDM seal, a 4.0 mm orifice, and operates at 230 V / 50 Hz within a pressure range of 0 to 5 bar.

Key Features

• Direct-acting, media-separated valve
• Maintenance-free pivoted armature technology
• Vibration-proof, block screwed coil system
• Service-friendly, robust manual override
• Solenoid coils moulded with chemically resistant epoxy

Circuit Function

This model operates under Circuit Function B (CF B):

Circuit function B (CF B): 2/2-way solenoid valve, direct-acting, normally open.

Technical Data

Property	Value
Orifice	DN 4.0 mm
Body Material	PP (Polypropylene)
Seal Material	EPDM
Port Connection	G 1/4 Internal thread
Voltage	230 V / 50 Hz
Pressure Range	0 - 5 bar
Kv Value (Water)	0.3 m³/h
Medium Temperature	-30 °C to +80 °C
Ambient Temperature	Max. +55 °C
Degree of Protection	IP65 with cable plug
Duty Cycle	40% duty cycle (60% intermittent operation) in 30 min for 8 W variant

Dimensions (Plastic Body)

D	L
G 1/4	12 mm

Note: The device can be attached via the existing holes on the bottom side. The hole pattern is 38x24. For plastic bodies, use either self-tapping screws or a body with metric thread inserts. The screw-in depth must be observed.

Safety and Installation

DANGER!

Risk of injury from high pressure in the system/device

• Before working on equipment or device, switch off the pressure and deaerate/drain lines.

Risk of injury from electric shock

• Before working on the system or device, switch off the power supply and secure against reactivation.
• Observe the applicable accident prevention and safety regulations for electrical devices.

WARNING!

Risk of burns or fire from hot device surfaces due to prolonged activation time

• Keep the device away from highly flammable substances and media and do not touch with bare hands.

Installation Notes

• Installation position: As required, preferably with actuator upright.
• Dirt trap: For safe operation of the solenoid valve, a dirt trap (≤ 500 µm) must be installed before the valve inlet.
• Manual override: When manual override is locked, the valve cannot be electrically actuated.